| 300 Big Block Modified |
 |
 |
|
1. Modified engines - unlimited cubic inch.
2. Vehicles bumping into this class from lower classes are allowed to run open exhaust.
3. MUST HAVE FULL ROLL CAGE.
4. Frame must be unaltered. Motor and axle locations unaltered.
5. Suspension must be factory design but traction devices may be added not to replace original. Ladder bars,
traction bars and floaters are acceptable.
6. Drive shaft loops are a must.
7. Gasoline aspirated engines only. Multi-carb engines allowed. Racing fuel allowed.
8. Stock appearing body.
9. Any D.O.T. tires - no cuts.
10. Single layer fire suit MUST be worn. Fire boots and gloves recommended.
11. D.O.T. approved helmet.
12. Four point seat belt harness required.
13. Gas pedals must be foot type with a return loop in case of throttle sticking. Double return springs on cable operated
pedals.
14. Must have a positive on/off switch that will completely diconnect vehicles ignition charge system readily accessable to
driver.
15. Must have on/off switch marked in red clearly marked KILL on rear externally mounted which is capable of completely
shutting vehicle down i.e. tailgate area.
16. Brakes must have ability to lock-up all four wheels. Drive line brakes are allowed.
17. Steering systems must be safe in both design and workmanship.
18. Trucks bumping into this class may run open exhausts.
19. Entry fee for this class is $25. Must be member.
|
|
| Last Updated ( Wednesday, 04 March 2009 02:11 ) |