| 200 Class - Small Block Modified - 400cc |
 |
 |
|
1. Modified engines - block up to 400cc is maximum. Trucks bumping into this class from Streetstock or Superstock are permitted, (big or small stock motors).
2. A non-notified cubic inch inspection may be done on any entrant but shall only be done prior to a race or
after the engine has been cleaned to the satisfaction of its owner.
3. MUST HAVE FULL ROLL CAGE.
4. Frame must be unaltered. Motor and axle locations unaltered.
5. Suspension must be factory design but traction devices may be added not to replace original. Ladder bars,
traction bars and floaters are acceptable.
6. Drive shaft loops are a must.
7. Gasoline aspirated engines only. Multi-carb engines allowed. Racing fuel allowed.
8. Stock appearing body.
9. Any DOT tires - no cuts.
10. Single layer fire suit (1 or 2 piece) MUST be worn.
11. D.O.T. approved helmet.
12. Four point seat belt harness required.
13. Gas pedals must be foot type with a return loop in case of throttle sticking. Double return springs on cable
operated pedals.
14. Must have positive on/off switch that will completely disconnect vehicles ignition charge system readily
accessable to driver.
15. Must have on/off switch marked in red clearly marked KILL on rear externally mounted which is capable of
completely shutting vehicle down i.e. tailgate area.
16. Brakes must have ability to lock-up all four wheels. Drive line brakes are allowed.
17. Steering sytems must be safe in both design and workmanship.
19. 100 and Superstock trucks bumping into this class are allowed to run open exhausts.
20. Entry fee for this class is $25 - must be member. |
|
| Last Updated ( Saturday, 25 July 2009 11:13 ) |