| 400 Class D.O.T. Rails |
 |
 |
|
1. Any size modified engines allowed with no cubic inch limit.
2. Altered frames permitted subject to safety in design and workmanship.
3. Motor location may be altered and is permitted subject to safety in design and workmanship.
4. DOT tires on back, cuts allowed on front only for trucks starting in this class. Lower class vehicles bumping
up to this class are permitted to run cut tires.
5. Roll cage mandatory and MUST pass safety inspection.
6. Drive shaft loops are a must.
7. Single layer fire suit (1 or 2 piece) must be worn.
8. D.O.T. approved helmet.
9. Four point harness a MUST.
10. This classes vehicles are open body style and is recommended to have arm restraints or nets.
11. Transmission Blanket - Automatic - Explosion Shield - Explosion Proof Clutch Bell Housing or shall have a
1/4" plate aluminium or 1/8" plate steel protector over the transmission and bell housing to protect driver.
12. Gasoline aspirated engines only. Multi-carb engines allowed. Racing fuel allowed.
13. Gas pedals must be foot type with a return loop in case of throttle sticking. Double return springs on cable
operated pedals.
14. Must have positive on/off switch that will completely disconnect vehicles ignition charge system readily
accessable to driver.
15. Must have on/off switch marked in red clearly marked KILL on rear externally mounted which is capable of
completely shutting down vehicle.
16. Brakes must have ability to completely lock up all four wheels. Drive line brakes are allowed.
17. Steering system must be safe in both design and workmanship.
18. This class vehicle must have 4 joint protectors full wrap around design 3" x 3/8" aluminum or 1/4" steel.
19. Entry fee for this class is $25. Pays back to 4th place. Must be a valid member. |
|
| Last Updated ( Wednesday, 04 March 2009 01:56 ) |